
Separate construction acceptance from maintenance monitoring
For new or modified pipework, start with the inspection plan: welds involved, required coverage, work sequence and acceptance criteria. During maintenance, service history and areas identified by the operator help establish useful examinations.
These situations do not automatically require the same programme. Thickness readings at selected locations do not replace weld examination, and weld testing does not establish the condition of the entire line.
- Identify sections, branches and welds by reference.
- Describe replacements, repairs or findings that prompted the request.
- Distinguish steam lines from condensate-return lines where both are included.
Make the inspection areas accessible
Operating status, temperature, insulation and access around the pipe affect preparation. Isolation and equipment handover conditions must be arranged with the operator. Work on a hot or operating line is not assumed to be feasible.
Concealed sections cannot be included as though they were directly accessible. Where insulation removal or special access is needed, preparation and reinstatement arrangements should be established before mobilisation.
- State whether insulation, paint or other surface protection is present.
- Provide heights, restrictions and possible access routes.
- Specify the shutdown window and expected examination temperature.
Select testing for the technical question
Visual examination can document the apparent condition of accessible areas. A surface examination suitable for the material may address open discontinuities. A thickness requirement needs defined measurement points or areas.
Volumetric weld testing is a separate objective. Selection depends on material, dimensions, geometry and the applicable specification. Ultrasonic feasibility is assessed against the actual configuration.
- Surface condition: identify what needs to be observed or detected.
- Thickness: define measurement locations, references and comparison data.
- Welds: provide joint details and the inspection specification.
Keep records that your teams can use again
The agreed report identifies pipe sections, examined areas and findings. For thickness measurements, repeatable identification helps locate points during later examinations. Comparisons also require knowledge of measurement conditions and limitations.
ISO 16809:2025 addresses ultrasonic thickness determination. Weld examination references are selected separately. The inspection dossier should identify who assesses the results and decides what action to take on the equipment.
- Measurement locations and units.
- Untested areas and restricted coverage.
- Agreed criteria and questions requiring additional examination.
Methods to consider for your specification
For observable features and anomalies in accessible areas.
It does not establish the condition of walls concealed beneath insulation.
For surface-breaking discontinuities in a compatible material and surface.
Preparation and examination conditions, including temperature, need confirmation.
Where surface or near-surface examination is relevant on ferromagnetic material.
Material grade and magnetization feasibility must be checked.
For defined thickness measurements or a technically suitable weld examination.
These objectives use different configurations; isolated readings do not establish the condition of a whole network.
Information needed for your quotation
- Line reference, location and pipework drawing or isometric.
- Material, diameter, nominal thickness and weld configuration.
- Objective: acceptance, post-repair testing, thickness or targeted investigation.
- Operating status, expected temperature, insulation and access.
- Available history, criteria and priority areas.
- Requested window and report requirements.